Table of Contents
Advertisement
Appendix B: Troubleshooting & FAQ
Question
The video and audio codec
is adopted in the ICA-312.
The maximum number of
users
access
ICA-312
simultaneously.
The ICA-312 can be used
outdoors or not.
The network cabling is
required for the ICA-312.
The
ICA-312
will
installed and work if a
firewall
exists
on
network.
The
username
password for the first time
or after factory default reset
Forgot the username and
password
Forgot the IP address of
the ICA-312.
IPWizard program cannot
Features
The ICA-312 utilizes MPEG-4 and M-JPEG dual compression to
providing high quality images. Where MPEG-4 is a standard for
video compression and M-JPEG is a standard for image
compression.
The audio codec is selectable by either AMR or G.726 compression.
The maximum number of users is 10. However, it also depends on
the total bandwidth accessed to this device from clients. The data
throughput of the device is around 20~25Mbps. Therefore, the
actual number of connected clients is varying by settings of
resolution, codec type, frame rate and bandwidth. Obviously, the
performance of the each connected client will slow down when many
users are logged on.
Yes, this ICA-312 is weatherproof. However, it might need to be
equipped with a weatherproof case for better performance.
Install ICA-312
The ICA-312 uses Category 5 UTP cable allowing 10 and/or 100
Base-T networking.
be
If a firewall exists on the network, port 80 is open for ordinary data
communication. This HTTP port and Video/Audio streaming ports
the
needs to be opened on the firewall.
and
Username = admin and leave password blank.
Note that it's all case sensitivity.
Follow the steps below.
1. Restore the factory default setting by press pressing and holding
down more than 3 seconds on ICA-312.
2. Reconfigure the ICA-312.
Check IP address of ICA-312 by using the IPWizard.exe program.
• Re power the ICA-312 if cannot find the unit within 1 minutes.
46/57
Answer or Resolution
Advertisement
Table of Contents
