Table of Contents
Advertisement
3.7.2 Maintenance
Factory Default: Reset this device to factory default settings. Note that click this button will
reset all device parameters to the factory settings.
Firmware upgrade: The device supports new firmware upgrade.
Unzip this firmware file to binary file and store it into your PC. Then follow the steps as bellows
carefully:
1. Close all other application programs which are not necessary for firmware update.
2. Make sure that only you access this device at this moment
3. Disable Motion Detection function.
4. Select "Firmware name"
5. Select the Firmware binary file.
to this device, once update, it will be burned into FLASH ROM of
6. Once the firmware file was selected, select "Upgrade".
7. The upgrade progress information will be displayed on the screen.
8. A message will be shown while the firmware upgraded. Once the upgrading
process completed, the device will reboot the system automatically.
9. Please wait for 80 seconds, and then you can use IPWizard to search the device again.
Warning!!!
The download firmware procedure cannot be interrupted. If the power and/or
network connection are broken during the download procedure, it might possibly cause
serious damage to the device.
Please be aware that you should not turn off the power during updating the firmware
and wait for finish message.
Furthermore, do not try to upgrade new firmware if it's not necessary.
(Note that it must make sure that the Firmware only applies
36/57
system.)
Advertisement
Table of Contents
