Fire Detection; Testing; Remote Monitoring; Maintenance - ADT NT9005 V1.0 NA User Manual

Fire Detection

This NT9005 controller is capable of monitoring fire detection devices such as
smoke detectors and providing a warning if a fire condition is detected. Good fire
detection depends on having an adequate number of detectors placed in appro-
priate locations. The system must be installed in accordance with NFPA 72
(N.F.P.A., Batterymarch Park, Quincey MA 02269). Carefully review Fire Safety on
page 21.
NOTE: Your installer must enable the fire detection portion of this equip-
ment for it to work.
To make sure your system continues to work as intended, you must test your sys-

Testing

tem weekly. Please refer to Testing your System on page 18. If your system does
not work correctly, call your installer for service.
Remote This system can send alarms, troubles and emergency messages over telephone
Monitoring lines to a central station. If you accidentally initiate an alarm, immediately call the
central station to prevent an unnecessary response.
NOTE: Your installer must enable remote monitoring for it to work.

Maintenance

With normal use, the system requires minimum maintenance, but please note the
following points:
1. Do not wash the security equipment with a wet cloth. Light dusting with a
2. Use the system test described on page 18 to check the battery condition of the
3. Consult the manufacturer's literature for testing and maintenance instructions
NOTE: The NT9005 is only compatible with DSC wireless devices.
slightly moistened cloth should remove normal dust accumulations.
NT9005 controller. DSC recommends that the standby battery be replaced
every three years.
for other system devices such as smoke detectors, motion detectors, and glass-
break detectors. For instructions on replacing detector batteries, see Replacing
Batteries on page 24.
I n tr o d u c t i o n
5