Table of Contents
Advertisement
Erasing a code
1. Press
2. Enter the number of the code you want to erase [01 to 32]. The Master code
3. To erase the code, press
4. To exit access code programming, press
Setting the
You should make sure that your system has the correct time and date. This is
Time and Date
important for the auto-arm feature to function correctly, and for accurate report-
ing of events.
1. To select time and date, press
2. Enter the time in hours and minutes using the 24 Hour format (00:00 to 23:59)
4. To exit programming, press
Turning the
If your installer has enabled the door chime feature, your NT9005 will beep when-
ever designated doors or windows are opened or closed. Your installer has pro-
Door Chime
On or Off
grammed which doors and windows will activate the door chime.
1. Press
2. Press
Changing the
There are several different tones that can be programmed for keypresses and other
Pitch of the
audible indications.
Keypad Tone
1. Press and hold
20
[Master Code]
5
cannot be erased.
then enter the date in months, days and years (MMDDYY) (November 26, 2000
= 112600).
to turn the door chime feature ON.
4
The keypad will beep 3 times.
again to turn the door chime feature OFF.
4
The keypad will sound one long beep.
The function button
pressed and held for 2 seconds. When door chime is enabled the keypad will
beep 3 times. When door chime is disabled the keypad will sound one long
beep.
. The NT9005 will cycle through the different tones avail-
able. Release the
.
#
[Master Code]
6
.
#
Chime
can also perform the same function if it is
key when the tone of your choice sounds.
.
.
1
Advertisement
Table of Contents
