Table of Contents
Advertisement
Entry/exit
Your installer will program the doors you usually use to enter or exit the premises
doors
as the entry/exit doors. These doors are programmed with entry and exit delay
times so that you can turn the system on and off without causing a false alarm.
Exit delay
A timer programmed by your installer. It starts when you turn on your system to
allow you a period of time to leave the premises. At the end of the exit delay time,
time
the system will be on.
Master code
The master code 4- or 6- digit access code, is used to set system options, to turn
the system on and off, and to program other access codes.
Turning on the system so that only the perimeter zones (see zone definitions,
Stay mode
below) are on. (Use when one or more people will stay on the premises.)
The NT9005 controller continuously checks the system for problems. If the control-
Trouble
ler finds a problem (trouble), it will indicate this at the keypad. See Checking
Trouble Conditions on page 16 for a list of possible trouble conditions, and how
they are displayed.
Zone
A limited area of the premises monitored by a detector (smoke detector, door/win-
dow contact, motion detector, glassbreak detector, etc.).
Perimeter zone: A zone that detects intrusion from outside the premises (e.g.,
door contact on an outside door, glassbreak detector).
Interior zone: A zone that detects intruders who have already entered (e.g., a
motion detector).
Fire zone: A zone that has a heat or smoke detector.
28
Advertisement
Table of Contents
