Single Tuner Mode - EchoStar HDS-600RS User Manual

If you see one of these screens, check your satellite input connections.
The unit offers you some or all of the following options:
Press the RED button to run the wizard again. Choose this option if

you have found and rectified a problem with your satellite connections.
If you have not identified the cause of the problem yet, press the
BLUE button (see Checking the Signals on the next page).
Press the GREEN button if you have only connected a single input

from your dish and this has been detected successfully by the unit
(see Single Tuner Mode, below).
Press the BLUE button to check your input signals (see Checking the

Signals on the next page).

Single Tuner Mode

If you have only connected a single input from your dish, and it has been
detected successfully by the unit, press the GREEN button to set the unit to
Single Tuner Mode.
Note. Functionality will be limited if only one signal used. We strongly advise
that 2 feeds are connected. If you do use a single feed, ensure you have
connected it to LNB1 – see page 8.
Note. If your satellite dish only has a single LNB do not attempt to split this to
create two inputs for the HDS-600RS. This approach does not work. You will
need to install a multiple-LNB.
Upgrading from Single Tuner Mode
If you upgrade your satellite receiver from a single to a dual system, you will
need to perform a factory reset to allow the unit's second tuner to operate (see
page 52). This action will delete your timed recording schedules but will not
delete existing recordings.
21