PARTS LIST
PARTS DIAGRAM
INSTALLATION & SETUP
Before connecting the water dispenser to a power source, let it stand upright for approximately
2 hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
LOCATION
The water dispenser should be placed on a firm, even foundation to minimize
noise and vibration.
Do not place the dispenser in direct sunlight or near other heat producing
appliances.
To avoid accidental water damage, locate it away from furniture or other
appliances.
The unit must be placed within reach of a properly rated grounded socket.
Never place any obstacles around the air inlet or outlet of the unit.
Allow a minimum 6-inch clearance on all sides for efficient operation.
5
A Name You Can Trust
1. Water guard
2. Cold tap (blue)
3. Warm tap (white)
4. Hot tap (red)
5. Drip tray
6. Storage cabinet
7. Cold switch (green)
8. Hot switch (red)
9. Refrigerating controller
10. Radiator
11. Drain plug
12. Power cord sets