Table of Contents
Advertisement
Chapter 4 Award BIOS Setup
4. PRIMARY MASTER/SLAVE UDMA
SECONDARY MASTER/SLAVE UDMA
Ultra DMA/33 implementation is possible only if your IDE hard drive
supports it and the operating environment includes a DMA driver
(Windows 95 OSR2 or a third-party IDE bus master driver). If you
hard drive and your system software both support Ultra DMA/33,
select Auto to enable BIOS support.
5. SATA MODE
Set the Serial ATA configuration. When set in Advanced Host
Controller Interface (AHCI) or RAID mode, the SATA controller is set
to Native mode. Configuration options: [IDE] [RAID] [AHCI]
SUPER IO DEVICE:
The options for these items are found in its sub menu. By pressing the
<ENTER> key, you are prompt to enter the sub menu of the detailed options
as shown below:
Onboard FDC Controller
Onboard Serial Port 1
Onboard Serial Port 2
UART Mode Select
X UR2 Duplex Mode
Onboard Parallel Port
Parallel Port Mode
X ECP Mode Use DMA
PWRON After PWR-Fail
↑↓→←:Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values
Descriptions on each item above are as follows:
1. ONBOARD FDC CONTROLLER
Select Enabled if the system has a floppy disk controller (FDC) installed
on the system board and you wish to use it. If you install and-in FDC or
the system has no floppy drive, select Disabled.
2. ONBOARD SERIAL PORT 1/2
Select an address and corresponding interrupt for the first and second
serial ports.
3. UART MODE SELECT
This item allows you to select UART mode.
Page: 4-16
Phoenix – Award CMOS Setup Utility
SuperIO Device
[Enabled]
[3F8/IRQ4]
[2F8/IRQ3]
[Normal]
[Half]
[378/IRQ7]
[SPP]
3
[Off]
F6:Fail-Safe Defaults
Item Help
Menu Level ►
F7:Optimized Defaults
PMB-601LF USER
'
S MANUAL
Advertisement
Table of Contents
