Infrared Remote Control - miniDSP Dirac DDRC-22A User Manual

To change the selected filter set
Briefly press the control knob. The Filter Set LED blinks quickly. Rotate the control knob until the
desired filter set LED is blinking. Press the control knob again, and the selected LED will remain
steady. (In the case of the DDRC-22D, this will advance to digital input selection.)
To change the selected source (DDRC-22D only)
Briefly press the control button twice. The Digital Source LED blinks quickly. Rotate the control
knob until the desired source LED is blinking. Press the control knob again, and the selected LED
will remain steady.
5.3 I
NFRARED REMOTE CONTROL
Many standard and programmable remote control units can be used with the Dirac Series processors. Instead of
adding another remote to your collection, the processor can "learn" the control codes of your current infrared
(IR) remote if it supports one of the following remote control codes:

NEC

Sony

Philips RC6

Apple Remote
Learning is done with the DDRC-22 utility program. After starting the program, click on the Connect button. To
initiate learning, simply click on one of the function buttons in the IR Learning box (Master Mute, Volume Up,
and so on). Then point your remote at the processor and click on the button that you want to use for that
function. A dialog will appear to show that the code was recognized. If the processor does not recognize the
remote control code, then it will time out and display a message saying that no IR code was detected.
miniDSP Ltd – Hong Kong / Email : info@minidsp.com / Features and specifications subject to change without prior notice
32