Drain Hose; Connecting To The Power Supply - Haier HWM85-1482 User Manual

Before use
Inlet Hose

Connect the nut on the inlet hose to the connector on
the water valve (fig1).

Apply inlet hose to a water tap with cold, fresh water
(fig2).
Use the hose-set supplied with the appliance.
Old hose-sets should not be reused.

Drain Hose


Use the drain hose bracket to keep the end of the drain
hose retained and prevent the outflow of water (fig1). Do
not extend the length of the drain hose; if an extended
hose is required, please consult a serviceman.

The height of the drainage outlet must be 80-100 cm. Fix
the drain hose to the clip at the back of the washing
machine to prevent it from dropping off (fig2).
The drain hose should not be submerged in water and should be securely fixed and leak-
free. If the drain hose is placed on the ground or if the pipe is at a height of less than
80cm, the washing machine will continuously drain while being filled (self-siphoning).

Connecting to the power supply

Before connecting to the power supply, check:

The socket is adequate for the maximum power of the washing
machine (For safety, fuses in the power circuit should be rated
for no less than 10A).

The voltage should meet the requirement.

The power outlet should be capable of accepting the washing
machine plug.

Connect the machine to an earthed socket outlet.
9