Related Manuals for Haier HWM85-728
Summary of Contents for Haier HWM85-728
- Page 1 Fully Automatic Washing Machine This manual is for HWM85-728 Please read this manual carefully before using. Retain it for future reference. 0030508582...
-
Page 2: Table Of Contents
CONTENTS Specification Names of the parts Water level/Water 1/18L 2/26L 3/34L 4/40L 5/46L Safety precautions quantity (about) 6/52L 7/57L 8/62L 9/66L 10/70L Installation and adjustment Water Injection pressure 0.03MPa 1.0MPa Install the water inlet hose Rated washing / Preparation before using spinning capacity Put in the laundries Usage of the detergent... -
Page 3: Names Of The Parts
Packing list Names of the parts × ° Ï ä Ë µ Ã ÷ Names of the parts Name Quantity One piece User's manual Top lid component Water inlet valve Warranty card One piece Detergent box Water absorption cushion Water inlet hose Control panel seat Back control Outer tub cover... -
Page 4: Safety Precautions
Trouble-shooting Answer to question Safety precautions (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department The washing machine must be positioned Please plug the power plug on special or after-sale service department of our company. - Page 5 Disposal after washing Safety precautions After using, please clean the lint and foreign materials of the lint filter etc. in time. Do not put hand into the rotating tub. It is dangerous Do not decompose, repair or alter the machine by Otherwise it may influence your using the machine.
-
Page 6: Installation And Adjustment
Installation and adjustment Please install and adjust the machine according to the requirement of the manual. Attention It is very important to your security and correct operating the machine. Even there's no water in the tub, a certain period is Install the bottom plate required before spin starting. -
Page 7: How To Change The Direction Of The Drain Hose
How to change the direction of the drain hose 6 START/PAUSE" button " WATER After the power is switched on, press it to start the machine 1.Loosen the screws of back cover, dismantle the back cover, then take off the drain hose LEVEL (As indicated figure 1) During working, push it to pause. -
Page 8: Install The Water Inlet Hose
Install the water inlet hose Confirm the water faucet 3 "PROCESS"button You can choose one or more process among soak, wash, rinse, spin. PROCESS The button is invaid if you choose QUICK or TUB DRY program. Water faucet,suitable Water faucet,not suitable You can not choose soak process if you choose WOOL program. - Page 9 4 Use the operation buttons Connection between the water inlet hose and the washer 1.Do not take off the water absorption cushion. Please check if the RESERVE(HOURS) nut of the water cushion is dropped or damaged before each usage. If it happens inlet hose MEMORY STANDARD...
-
Page 10: Preparation Before Using
1 Preparation before washing 2.Put in the laundries The capacity of washing and spinning of he Preparation before washing machine refer to the largest weight of the standard 1.Connect the water inlet hose laundries under dry condition that can be washed or 2.Confirm that the washing machine is earthed spinned in one time.One time washing quantity shall be lower than the rated capacity.