Installable Drive Enclosures; Drive Enclosure Rack Installation Procedure - Fujitsu Eternus DX60 User Manual

Chapter 8 Installing Optional Products
> 8.2 Drive Enclosure Installation
8.2.2

Installable Drive Enclosures

Refer to
• ETERNUS DX60 drive enclosures
Up to one 3.5" type drive enclosure can be installed in the 3.5" disk model.
• ETERNUS DX80/DX90 drive enclosures
-
-
At time of purchase, the drive enclosure model may be different from those described.
The latest manual is available via the following web-site, and should be referred to as necessary.
http://www.fujitsu.com/global/services/computing/storage/eternus/products/diskstorage/dx-
entry/
8.2.3

Drive Enclosure Rack Installation Procedure

This section describes how to install a drive enclosure in a rack.
P3AM-3042-06ENZ0 ETERNUS DX60/DX80/DX90 Disk storage system User Guide
"A.2.2 Drive Enclosures" (page 225)
Drive enclosures cannot be installed in the ETERNUS DX60 2.5" disk
model.
Up to nine 3.5" type drive enclosures can be installed in the 3.5" disk model.
Up to four 2.5" type drive enclosures can be installed in the 2.5" disk model. 3.5" type drive
enclosures may also be in the 2.5" disk model. In this case, the maximum number of disks
allowed determines the maximum number of drive enclosures that may be installed.
Do
CAUTION
• If drive enclosures are installed in a way other as described herein,
damage and/or device failure or electrical shock may occur.
• Make sure to install the drive enclosures in order, above the
controller enclosure.
• Do not install drive enclosures with cables, such as power cords,
connected.
• The drive enclosure contains delicate components, and should be
handled gently. Do not drop or knock the drive enclosure against the
rack when installing it. Also, do not knock the other devices installed
in the rack.
• When no other components are to be installed in a drive slot, install
the dummy disk units provided with the rack.
for a list of drive enclosures that may be installed.
192
Copyright 2010 FUJITSU LIMITED