Register A Handset - VTech CS6648-2 User Manual

Register a handset

The cordless handsets provided with
your telephone system are already
registered as HANDSET 1, and so
forth. Additional handsets registered
to the telephone system are assigned
numbers in the sequential order. This
telephone system accommodates up to
five handsets.
You can add new handsets (CS6609,
purchased separately) to your
telephone system. Each handset must
be registered with the telephone base
before use. When first purchased and
properly charged, each expansion
handset displays To register HS and
See manual alternately. The new
handset should be charged without
interruption for at least 30 minutes before
registering it to the telephone base.
Make sure the handset is out of the
handset charger and is put near the
telephone base. Make sure the handset
alternately shows To register HS
and See manual before you begin
registration.
To register a handset:
1. Press and hold FIND HANDSET on
the telephone base for about four
seconds until the IN USE light turns
on and it shows Registering...
2. Press QUIET
handset shows Registering... Both
the telephone base and cordless
handset show Registered, and you
hear a beep from the handset when
the registration process completes.
The registration process takes about
60 seconds.
If registration fails, the handset displays
Failed. Try again the registration process
above.
#
on the handset. The
NOTES
• You cannot register a handset if any other
system handset is in use.
• If you have not set the date and time for
the telephone system, the handset will
prompt you to set the date and time after
it is registered to the base. To skip setting,
press
CANCEL
• You can only register one handset to the
telephone base at a time.
37
.