Toshiba Satellite A100 Maintenance Manual page 91

3.2 Quick Start
7 Test5
8 Inspection
9 Setting
Calibration
data
If it succeeded, the system will prompt a message of PASS, otherwise the message will
be FAIL.The test information will be written in log file.
Note:
Please do not use this program, when you test PC without 3D sensor.
The display of a test program and the set method of PC are shown below.
Display of a Test Program
Set method of PC
r
Uppe
Judgment
If all data is less than ranges, it will be OK.
Judgment
If all data is less than ranges, it will be OK.
When an inspection result is O.K., calibration at HPC.
Satellite A100/A105 / TECRA A7 Maintenance Manual
3 Diagnostic Programs
Left
15