Chapter 5
General Settings
5.7
RAID Configuration Settings
8
Check the setting completion message and click the [Done] button.
The screen display returns to the [Network] screen.
5.7
RAID Configuration Settings
Use ETERNUS Web GUI to set RAID configurations in the ETERNUS DX Disk storage system.
Perform the following settings:
•
RAID group creation
Volume creation
•
Hot spare registration
•
This section describes the configuration settings using a case of creating the following volumes as an exam-
ple.
Operation volume
•
Create an operation volume (Standard) in RAID5(4+1) RAID group.
Backup volume
•
Create a generation management volume (SDV) and temporary work volume (SDPV) in RAID5(2+1) RAID
group.
5.7.1
RAID Group Creation
Create RAID groups (groups of drives that configure RAID in the ETERNUS DX Disk storage system) to create
volumes.
Create an operation RAID group and a backup RAID group.
Figure 5.7 RAID Group Creation
Operation RAID group (RG0)
600GB
600GB
600GB
RAID5 (4+1)
Table 5.1 RAID Group Creation
Usage
Operation RAID
group (copy source)
Backup RAID group
(copy destination)
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Backup RAID group (RG1)
600GB
600GB
Item
RG0
RG1
Copyright 2014 FUJITSU LIMITED
2TB
2TB
2TB
RAID5 (2+1)
Create mode
RAID type
Manual
RAID5
Manual
RAID5
88
Configuration drive
600GB SAS disk ´ 5
2TB Nearline SAS
disk ´ 3
P3AM-7652-02ENZ0