Chapter 5
General Settings
5.4
Storage Management (Initial Setup 1)
Do not use the RMT port for an operation management LAN. Use the RMT port only for remote sup-
•
port.
Configure the IP address for the MNT port with an IP address in a different subnetwork than the
•
RMT port.
•
When specifying the IP address of the Slave CM, specify an IP address that is in the same subnet
but is different from the IP address of the Master CM.
•
Either or both an IPv4 address and an IPv6 address can be specified for the MNT port and the RMT
port.
(1)
Click the [IPv4 Settings] tab to specify an IPv4 address. Click the [IPv6 Settings] tab to specify an
IPv6 address.
The following procedure shows an example when selecting the [IPv4 Settings] tab.
A confirmation screen appears.
(2)
Click the [OK] button.
The network environment setting is applied and the setting completion screen appears.
(3)
Click the [Done] button.
The [Logout] screen appears.
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
83
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0