Power Synchronized Unit Connection; Power Cord Connection - Fujitsu ETERNUS DX200 S3 Configuration Manual

Chapter 4 Connecting Cables
4.3

Power Synchronized Unit Connection

Connect the cable between enclosures in the same way as
Drive enclosure 2
Drive enclosure 1
4.3 Power Synchronized Unit Connection
When using a power synchronized unit for power control, connect the power synchronized unit to the ETER-
NUS DX Disk storage system.
Refer to "Configuration Guide (Power Synchronized Unit)" for details about power synchronized units, the pro-
cedure for connecting power synchronized units to the ETERNUS DX Disk storage system, and required set-
tings.
4.4

Power Cord Connection

Connect the power cords to the ETERNUS DX Disk storage system.
The controller enclosure and drive enclosure (2.5" type and 3.5" type) have two power supply units (PSU#0
and PSU#1).
The high-density drive enclosure has four power supply units (PSU#0, PSU#1, PSU#2, and PSU#3).
Make sure that power cords are connected to all power supply units.
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
62
Copyright 2014 FUJITSU LIMITED
Step (1).
P3AM-7652-02ENZ0