Enroll Thermostat Into Schlage Link; System - Trane TZEMT400AB32MAA User Manual

21
Prepare the bridge for enrollment.
a. Unplug Ethernet and power cables from bridge.
b. Verify that blue light is blinking. If blue light is solid, battery is dead.
c. Install a quality 9 volt battery.
d. Take bridge to the location where the thermostat is mounted.
22
Enroll the thermostat into the bridge.
If you are using a controller that is not a Schlage LiNK
consult the instructions that came with the controller to fi nd out how
to enroll a new device.
a. Hold the bridge within 6 feet (1.8 meters) of the thermostat
throughout all of step 2.
Important Note: After you begin the enrollment process, you have
30 seconds to complete the remainder of the steps. Study the steps
below before beginning.
b. Press and release the plus (+) button on the bridge.
c. Press the MENU button on the thermostat.
d. Scroll down to
e. Press the Yes button to enroll the thermostat.
f. Observe the lights on the bridge. The orange light will blink
while enrollment is taking place. Enrollment is complete
when the orange light becomes solid.
11:15 AM
MENU MODE
MENU button
23
Verify enrollment of the thermostat.
a. Press the MENU button on the thermostat.
b. Scroll down to
c. Look at the number listed after
If the number listed there is anything other than "000", the thermostat
has been successfully enrolled.
If the number listed there is "000", the thermostat has NOT been
successfully enrolled. In this case, repeat step 22 and verify again.
Press Done button when fi nished.

Enroll Thermostat into Schlage LiNK

Z Wave Install, and press the Select button.
Outside 60
76 H
75
74 C
FAN RUN
Thermostat Info, and press the Select button.
ZNID.
TM bridge,
Menu Selection
User Settings
Usage Graph
ESM Setpoints
ZWave Install
Done
TZEMT400AB32
ZVER:02.00.0
ZHID: 01.07.37.a7
System Type:
Fan Type:
Done
TM

System

Select
Select button
Thermostat Info
Ver: 01.00.10
ZNID: 013
Standard
Gas
Scroll
down
ZNID
10