Table of Contents
Advertisement
Interface
(30) SET FEATURES (X'EF')
The host system issues the SET FEATURES command to set parameters in the
Features register for the purpose of changing the device features to be executed.
Upon receipt of this command, the device sets the BSY bit of the Status register
and saves the parameters in the Features register. Then, the device clears the BSY
bit, and generates an interrupt.
If the value in the Features register is not supported or it is invalid, the device
posts an ABORTED COMMAND error.
Table 5.23 lists the available values and operational modes that may be set in the
Features register.
Table 5.23 Features register values and settable modes
Features
Register
X'02'
Enables the write cache function.
X'03'
Set the data transfer mode. *1
X'05'
Enables the advanced power management function. *2
X'42'
Enables the Acoustic management function. *3
X'55'
Disables read cache function.
X'66'
Disables the reverting to power-on default settings after software reset. (*1)
X'82'
Disables the write cache function.
X'85'
Set the advanced power management mode to Mode-0.
X'AA'
Enables the read cache function.
X'BB'
Specifies the transfer of 4-byte ECC for READ LONG and WRITE LONG
commands.
X'C2'
Disables the Acoustic management function.
X'CC'
Enables the reverting to power-on default settings after software reset. (*1)
*1 Although there is a response to the command, nothing is done.
At power-on or after hardware reset, the default mode is set as follows.
Write cashe function
Transfer mode
Advanced power
management function
Acoustic
management function
Read cashe function
5-88
Drive operation mode
: Enabled
: PIO Mode-4, Multiworld DMA Mode-2
: Enabled (Mode-1)
: State keeping
: Enabled
(*1)
C141-E202-01EN
Advertisement
Table of Contents
