Dhcp Server Settings - D-Link DHP-1565 User Manual

Section 3 - Configuration
DHCP stands for Dynamic Host Control Protocol. The DHP-1565 has a built-in DHCP server. The DHCP Server will automatically assign an IP address
to the computers on the LAN/private network. Be sure to set your computers to be DHCP clients by setting their TCP/IP settings to "Obtain an IP
Address Automatically. " When you turn your computers on, they will automatically load the proper TCP/IP settings provided by the DHP-1565. The
DHCP Server will automatically allocate an unused IP address from the IP address pool to the requesting computer. You must specify the starting
and ending address of the IP address pool.
Check this box to enable the DHCP server on your router.
Enable DHCP
Server: Uncheck to disable this function.
DHCP IP
Enter the starting and ending IP addresses for the DHCP server's
Address
IP assignment.
Range:
Note: If you statically (manually) assign IP addresses to your
computers or devices, make sure the IP addresses are outside of
this range or you may have an IP conflict.
DHCP Lease
The length of time for the IP address lease. Enter the Lease time
Time:
in minutes.
Learn NetBIOS
If NetBIOS advertisement is switched on, switching this setting
on causes WINS information to be learned from the WAN side,
WAN:
if available. Turn this setting off to configure manually.
NetBIOS scope:
This is an advance setting and is normally left blank. This allows the configuration of NetBIOS domain name under which network
hosts operate. This setting has no effect if the " Learn NetBIOS information form WAN is activated.
When you have finished configuring the new DHCP Server Settings, click the Save Settings button at the top or bottom of the window.
D-Link DHP-1565 User Manual
Network Settings

DHCP Server Settings

42