Oki MC860 User Manual page 82

F Code communication
F Code transmission is a function to communicate, using sub addresses or passwords in
accordance with the ITU-T standard. By creating F code boxes/sub addresses/passwords,
you can execute secure communication, bulletin box communication and polling
communication.
NOTE
> Up to 20 F code boxes can be registered.
> Up to 30 documents can be stored in one box.
Sub address, password and ID code
> A sub address is a number to distinguish various F code boxes that are set in the
memory.
> A password is a key to prevent wrongful sending and receiving.
> An ID code is a key to access a secure box.
By using a sub address and password, the following functions can be used:
> F Code Secure Communication
When an F code secure box is set in the recipient machine, by specifying the sub
address and password (if necessary) of its box, secure communication can be
executed.
On the receiving side of the secure communication, unless the specified ID code is
entered, a received document cannot be printed, therefore, this function is useful
when sending a document that needs a security protection. Refer to
> "Transmission using a sub address (F code transmission)" on page
> "Printing stored documents" on page
> F Code Bulletin Box Communication
When the F code bulletin box is set in the recipient machine, by specifying the sub
address of its notice board, a document can be sent to the bulletin box or a document
stored in the bulletin box can be taken out (polling). (A password can be specified, if
necessary.) Refer to:
> "Transmission using a sub address (F code transmission)" on page
> "Receiving using a sub address (F code polling)" on page
> "Storing documents to the notice board" on page
Registering an F code box
To use F code communication, register an F code box. Register a sub address and password
in each F code box.
NOTE
Make sure to register a sub address. Register a password, if necessary.
When a secret number is set, only the specific person can operate the F code
box.
1. Press the SETUP button on the control panel.
2. Press Admin Setup.
3. Enter an administrator's password and press Enter.
4. Press Fax Setup.
5. Press F-Code Box.
88.
87.
Operation > 82
86.
86.
87.