Igmp Snooping Multicast Vlan Settings - D-Link xStack DES-3200-10 User Manual

xStack

IGMP Snooping Multicast VLAN Settings

This window is used to configure the IGMP Snooping Multicast VLAN settings on the Switch.
To view this window, click L2 Features > IGMP Snooping > IGMP Snooping Multicast VLAN Settings:
The following fields can be set
Parameter Description
ISM VLAN Global
State
VLAN Name
VID (2-4094)
State
Replace Source IP
Member Port (e.g.:
1-4, 6)
Source Port (e.g.:
1-4, 6)
Tagged Member
Port (e.g.: 1-4, 6)
Untagged Source
Port (e.g.: 1-4, 6)
Remap Priority
(Value 0-7)
Replace Priority
To edit an entry, click the corresponding Edit button. To delete an entry, click the corresponding Delete button.
To add a multicast VLAN to a profile that has been created, click the corresponding hyperlinked
the following window:
®
DES-3200-10/18/28/28F Layer 2 Ethernet Managed Switch User Manual
Figure 3 - 29. IGMP Snooping Multicast VLAN Settings window
Click the Enabled or Disabled radio button to enable or disable multicast VLAN.
This is the VLAN Name that, along with the VLAN ID, identifies the VLAN the user wishes to
add or modify the IGMP Snooping Settings for.
This is the VLAN ID that, along with the VLAN Name, identifies the VLAN the user wishes to
add or modify the IGMP Snooping Settings for.
Enable or disable multicast VLANs for the chosen VLAN.
With the IGMP snooping function, the IGMP report packet sent by the host will be forwarded to
the source port. Before forwarding of the packet, the source IP address in the join packet
needs to be replaced by this IP address. If none is specified, the source IP address will not be
replaced.
A range of member ports to add to the multicast VLAN. They will become the untagged
member ports of the ISM VLAN.
Select the source Port for the multicast VLAN.
Specifies the ports that will be tagged as members of the multicast VLAN.
A range of untagged source ports to add to the multicast VLAN. The reassigned PVID of the
untagged source port will be automatically changed to the multicast VLAN.
The remap priority is associated with the data traffic to be forwarded on the multicast VLAN. If
None is selected, the packet's original priority will be used.The default setting is None.
Tick this option so that the packet's priority will be changed based on the remap priority by the
Switch. This option takes effect only when remap priority is set.
81
Group List to reveal