D-Link xStack DES-3200-10 User Manual page 184

xStack
Parameter Description
The pre-configured Profile ID for which to configure the Flow Metering parameters.
Profile ID
The pre-configured Access ID for which to configure the Flow Metering parameters.
Access ID
(1-65535)
Enter the appropriate information and click Find. The entries will be displayed on the lower half of the table. To edit an
entry, click the corresponding Modify button. To delete an entry, click the corresponding Delete button. To add a new
entry, click the Add button, which will display the following window for the user to configure:
The following fields may be configured:
Parameter Description
Use the drop-down menu to select the pre-configured Profile ID that will be used to configure the
Profile ID
Flow Metering parameters.
Enter the Access ID that will be used to configure the Flow Metering parameters, enter a value
Access ID
between 1 and 65535.
(1-65535)
Single-rate Two-Color Marker, marks packets green or red based on a rate and burst size. This
Mode
is useful when only burst size matters.
Violate – Specifies the action when the packet is in "red color" mode.
Action
Click Apply to implement changes made, click <<Back to return to the ACL Flow Meter window.
®
DES-3200-10/18/28/28F Layer 2 Ethernet Managed Switch User Manual
Figure 6 - 56. ACL Flow Meter Configuration window
•
Rate (64-1024000) Kbps – Specifies the committed bandwidth in Kbps for the flow. The
range is from 64 to 1024000. The unit is Kbps.
•
Burst Size (0-1016) Kbyte – Specifies the burst size for this flow. The range is from 0 to
1016. The unit is Kbyte.
•
Permit – Permits the packet.
•
Replace DSCP – Change the DSCP of the packet.
•
Drop – Drops the packet.
183