D-Link xStack DES-3200-10 User Manual page 80

xStack
The following fields can be set.
Parameter Description
VLAN ID
VLAN Name
Querier Expiry
Time
Querier IP
Max Response
Time (1-25)
Query Interval
(1-65535)
Last Listener
Query Interval
(1-25)
Robustness Value
(1-255)
Querier State
Fast Done
State
Data Driven
Learning Aged Out
Version
Querier Role
To modify the IGMP Snooping Router Port Settings, click on the
following window for the user to configure:
®
DES-3200-10/18/28/28F Layer 2 Ethernet Managed Switch User Manual
Figure 3 - 26. IGMP Snooping Settings (Edit) window
This is the VLAN ID that, along with the VLAN Name, identifies the VLAN for which the user
wishes to modify the IGMP Snooping Settings.
This is the VLAN Name that, along with the VLAN ID, identifies the VLAN for which the user
wishes to modify the IGMP Snooping Settings.
Displays the querier expiry time.
The IP address of the device which acts as the IGMP querier for the network.
This determines the maximum amount of time in seconds to wait for reports from members.
The Max Response Time field allows an entry between 1 and 25 (seconds). The default is 10.
The Query Interval field is used to set the time (in seconds) between transmitting IGMP
queries. Entries between 1 and 65535 seconds are allowed. The default is 125.
This field specifies the maximum amount of time between group-specific query messages,
including those sent in response to leave group messages. The default is 1.
Adjust this variable according to expected packet loss. If packet loss on the VLAN is expected
to be high, the Robustness Variable should be increased to accommodate increased packet
loss. This entry field allows an entry of 1 to 255. The default is 2.
Choose Enabled to enable transmitting IGMP query packets or Disabled to disable the
transmitting of IGMP query packets. The default is Disabled.
This parameter allows the user to enable the Fast Leave function. Enabled, this function will
allow members of a multicast group to leave the group immediately (without the
implementation of the Last Member Query Timer) when an IGMP Leave Report Packet is
received by the Switch. The default is Disabled.
Select Enabled to implement IGMP Snooping. This field is Disabled by default.
Allows users to enable or disable aged out of IGMP Snooping data driven learning for the
specified VLAN.
Allows the user to configure the IGMP version used on the Switch. The default value is 3.
This read-only field describes the behavior of the Switch for sending query packets. Querier will
denote that the Switch is sending out IGMP query packets. Non-Querier will denote that the
Switch is not sending out IGMP query packets. This field will only read Querier when the
Querier State and the State fields have been Enabled.
Modify Router Port
79
hyperlink, which will show the