Ospf Interface Configuration - D-Link DES-6500 User Manual

D-Link DES-6500 Layer 3 Stackable Gigabit Ethernet Switch
See the parameter descriptions below for information on the OSPF Area ID setting.
The Area ID settings are as follows:
Parameter
Area ID
Type
Stub Import
Summary LSA
Stub Default Cost

OSPF Interface Configuration

To set up OSPF interfaces, click the OSPF Interface Settings link to view OSPF settings for
existing IP interfaces. If there are no IP interfaces configured (besides the default System
interface), only the System interface settings will appear listed. To change settings for in IP
interface, click on the hyperlinked name of the interface to see the configuration menu for that
interface.
Description
A 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that
uniquely identifies the OSPF area in the OSPF domain.
This field can be toggled between Normal and Stub using the space bar.
When it is toggled to Stub, additional fields appear − Stub Import Summary
LSA, and Default Cost.
Displays whether or not the selected Area will allow Summary Link-State
Advertisements (Summary LSAs) to be imported into the area from other
areas.
Displays the default cost for the route to the stub of between 0 and 65,535.
The default is 0.
Figure 4- 64. OSPF Interface Configuration
110