Using The Side Burner; Care & Maintenance Of Side Burner - Jenn-Air 720-0336 Instructions Manual

USING THE SIDE BURNER

Inspect the gas supply hose prior to turning on the
gas. If there is evidence of cuts, wear or abrasion, it
must be replaced prior to use. Do not use the side
burner if gas odor is present.
WARNING
When lighting, always keep your face and body as
far away from the burner as possible.
LIGHTING INSTRUCTIONS
1. Open the top cover or lid. Remove any cooking
utensils that are near the burner grate.
2. Push and turn the control knob
counterclockwise to the "IGNITE / HI" setting.
You should hear a "clicking" sound if the
electronic ignition system is working properly.
3. If the burner does not light within 4 seconds,
turn the control knob to the "OFF" position.
CARE & MAINTENANCE OF SIDE BURNER
BURNER CLEANING
Clean the exterior of the burner with a wire brush.
Clear any clogged burner ports with a straightened
paper clip. Never enlarge the burner ports. Never
use a wooden toothpick as it may break off and
clog the port.
SIDE BURNER GRATE
The top burner grate is stainless steel. To avoid
burns, do not clean the grates while they are hot.
While in place, they may be washed with hot, soapy
water, rinsed and wiped dry. Never immerse hot
grates in water.
4. If the smell of gas is detected and the igniter is
not functioning, immediately turn the control
knob to the "OFF" position.
5. Allow 5 minutes for any accumulated gas to
dissipate. If the side burner igniter will not
function, follow the match lighting instructions
below.
MATCH LIGHTING
1. Insert a match into the lighting rod. Ignite the
match and place near the side burner ports.
2. Turn the control knob counterclockwise to the
"IGNITE / HI" setting. The side burner should
light immediately.
3. Rotate the control knob to the desired setting.
STAINLESS STEEL
There are many stainless steel cleaners
available. Always use the mildest cleaning
procedure first, scrubbing in the direction of the
grain. Do not use steel wool as it will scratch the
surface.
To touch up noticeable scratches in the stainless
steel, sand very lightly with dry 100 grit sand
paper in the direction of the grain.
19