Mower Blades - Dixon ZTR 6000 SERIES Operator's Manual

CARE AND MAINTENANCE
CAUTION

MOWER BLADES:

Check sharpness of mower blades after every 10 hours of operation.
To sharpen blades, proceed as follows.
1.
2.
3.
4.
5.
Stop engine and remove ignition key for safety.
Wear heavy, thick gloves when holding onto cutter
blade, avoid the sharp edge of the blade.
Remove bolt and flat washer mounting blade on shaft.
Remove blade.
Blades should be discarded when worn excessively.
Sharpen blade with a hand file, electric grinder or blade
sharpener. Wear gloves and eye protection when
sharpening. Grind blade at original 25 degree bevel.
Check balance of blade by positioning the blade on a nail
or blade balance pedestal. Grind the blade on the end that
is heavier until both sides balance.
Install blade, flat washer & bolt. Make sure to tighten
bolt to 60 ft. lbs.
New Blade
When notch starts,
discard blade
DANGEROUS!
DO NOT USE
BLADE IN THIS
CONDITION!
27