Specifications - Dixon ZTR 6000 SERIES Operator's Manual

CHASSIS:
BODY:
SEAT:
MOWER DECK:
BLADE DRIVE:
DRIVE SYSTEM:
ENGINE:
STARTING SYSTEM:
TIRES:
RECOMMENDED
TIRE PRESSURE:
CAPACITIES:
DIMENSIONS:
Additional information provided in service instructions under the individual component.

SPECIFICATIONS

6000 Series Forward Mount
Sheet metal construction frame.
Folded sheet metal. Seat lifts up for access to battery and belt service.
Designed for operator comfort by use of high density closed cell foam
padded back and arm rests, upholstered with CorduraTM water-
repellent fabric. Seat is adjustable fore and aft.
Two decks are available. Both are made of 12 GA fabricated welded
construction with 10 GA reinforcement plate. Three blades
combine for either a 48" or 60" cut width. Cut height approximately 1"
to 5" via 9 position lift handle.
Electric clutch.
Each rear wheel is independently driven by a HydroGear BDU-10L Series
70 hydrostatic transmission. The hydrostatic transmissions, in turn,
power a fully enclosed HydroGear gearbox.
23 HP Kohler Command, 4-cycle, v-configuration, overhead valve, air
cooled, gasoline, horizontal shaft, aluminum head, and crankcase with
cast iron liners, full pressure lubrication/full flow filter, pulse-type fuel
pump, fixed jet carburetor w/smart-choke, electronic ignition, in-line fuel
filter, dual element air cleaner.
Electric by key switch operation with safety interlocks on parking brake
and blade drive clutch.
Front 4.10 x 3.50-4
Rear 6.00 x 13.00-5
Drive 10.0 x 10.00-20
Front 16 lbs.
Rear 12 lbs.
Fuel - 5 gallons
Hydrostat oil tank - 3 quart with in-line 40 micron filter
Hydrostat oil recommendation, refer to page 29
Engine - 2 quarts SAE 10W30 (with filter)
Width 57-1/2"(48" Deck) 69-1/2" (60" Deck)
Height 45-1/2"
Length 96" (48" Deck), 101" (60" Deck)
Weight 960 lbs. (48" Deck), 1030 lbs. (60" Deck)
13