Specifications - Dixon ZTR 4500 series Operator's Manual

CHASSIS:
BODY:
MOWER DECKS:
BLADE DRIVE:
TRANSMISSION:
ENGINE:
Model 4515B:
Model 4516K:
STARTING SYSTEM:
TIRES:
RECOMMENDED
TIRE PRESSURE:
CAPACITIES:
DIMENSIONS:
NOTE:

SPECIFICATIONS

Models ZTR 4515B and 4516K
Twin 12 gauge side frames and 7 gauge transmission and engine base plate.
All body parts are made of high density polyethylene. Dent and corrosion resistant.
Front body contains access panel for battery service.
42" Deck: 13 GA Stamped Steel Construction - 42" Cut Width
50" Deck 11 GA Fabricated Construction/Reinforcement Ribs - 50" Cut Width
Cut height approximately 1" to 4" via 7 position lift handle.
Electric clutch.
Each rear wheel is independently driven by a HydroGear IZT hydrostatic drive.
15.5 HP Vanguard Briggs & Stratton, 4-Cycle, Single Cylinder, Overhead Valve,
Air-Cooled, Gasoline, Vertical Shaft With Cast Iron Cylinder Sleeve, Oil Pump
With Integral Oil Filter.
16 HP Kohler Command 16, 4-Cycle, Single Cylinder, Overhead Valve, Air-
Cooled, Gasoline, Pressure Lubricated, With Oil Filter, Vertical Shaft, Aluminum
Head and Block with Cast-Iron Cylinder Liner. Smart Spark Ignition.
Electric by key switch operation with safety interlock blade drive.
Front 11 X 4.00 X 5 ribbed tread.
Rear 18 X 8.50 X 8 Multi-Trac
Front 16-21 lbs.
Rear 8-14 lbs.
Fuel 2.7 gallons total.
Engine Briggs & Stratton - 1.50 quarts oil.
Kohler - 2 quarts oil with filter.
Width 44" Maximum Track Width
Height 42" to top edge of seat.
Length 72" hitch tab to front bumper.
Weight Power Unit:
w/42" Deck:
w/50" Deck:
Additional information provided in service instructions under the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
463 lbs.
547 lbs.
603 lbs.
Page 11