Page of 6
Download Bookmark Comment

Dixon ZTR 428 User Manual

Dixon lawn mower user manual.
Hide thumbs
   
TECHNICAL DATA BROCHURE - ZTR 428 & 429
DATE 8/89 (Rev.)
PAGE 1 of 11
MPORTANT -- READ OPERATOR'S MANUAL BEFORE OPERATING OR MAKING ADJUSTMENTS.
Deluxe Seat Adjustment
Easy hand lever action allows forward and backward movement, of seat.
No bolts to loosen or tighten.
Mower Blade Operation
1.
To start mower blades, pull up slightly on blade drive switch handle
and move it forward to the "ON" position.
2.
To stop mower blades, move switch handle to the "OFF" position.
Body Removal
1.
Disconnect throttle cable from engine.
2.
Disconnect rear wiring loon from the body-by turning the threaded collar
on connector in a counterclockwise direction.
This plug is located at
the right rear of body.
3.
Remove the four control lever bolts and remove upper control levers
(P/N 9079 A 9080).
4.
Remove the two acorn nuts on floor of body and release latches on
the rear of body near each side.
5.
Place height adjustment lever in the vertical position, engage the
parking brake and carefully l i f t body off the chassis.
6.
Reverse above procedures to install body.
S a f e t y Checks -- "Important"
1.
After reassembly of body onto chassis and while seated on the mower,
attempt to start the engine with mower deck engaged.
The engine should
not start.
If engine does start, return mower to an Authorized Dixon Dealer
for adjustment or repair.
2.
Disengage mower deck and start engine with the operator in a normal seated
position on the mower.
Engage mower deck and remove weight from the
seat.
The engine should stop.
If engine does not stop when operator rises
from seat, return mower to an Authorized Dixon Dealer for adjustment or
repair.
Parking Brake Adjustment
1.
Remove body as described above.
2 .
Adjustment points are located at rear of transaxle on each side.
Remove roll pins from swivel fitting (P/N 2172).
Turn swivel fitting on
brake rod (P/N 6100) in, to tighten.
Just enough to prevent brake from
slipping when engaged. 3.
Reinstall roll pin.
CAUTION: Over tightening may cause premature wear, on bra ke band
(P/N 6085).
.
Dixon Industries, INC
Box 1569
Coffeyville, Kansas 67337-0945
(316)251-2000
Airport Industrial Park
TELEX: 417109

   Related Manuals for Dixon ZTR 428

   Summary of Contents for Dixon ZTR 428

  • Page 1

    Disengage mower deck and start engine with the operator in a normal seated position on the mower. seat. The engine should stop. from seat, return mower to an Authorized Dixon Dealer for adjustment or repair. Parking Brake Adjustment Remove body as described above.

  • Page 2

    CHASSIS ASSEMBLY (MODEL 429 & 428)

  • Page 3

    BODY ASSEMBLY (MODEL 429 & 428)

  • Page 4

    ENGINE ASSEMBLIES (MODEL 429 & 428)

  • Page 5

    WIRING (MODEL 429 & 428)

  • Page 6

    Using the lift handle, raise the Measure from surface to the bottom of the cutter blade Using the nut on the single front L-rod, Ground speed, grass conditions, DIXON INDUSTRIES, INC. Coffeyville, Kansas 67337-0945 (316)251-2000 TELEX 417100 Page 11 of 11...

This manual also for:

Ztr 429

Comments to this Manuals

Symbols: 0
Latest comments: