Pro-Form 2.0 ES User Manual page 10

9. Hold the Console Plate (19) near the Upright (3).
Insert the Main Wire (31) upward through the
Console Plate.
Next, insert the Console Plate (19) into the
Upright (3), and align the indicated large holes.
10. Have a second person hold the Handlebar (47)
near the Upright (3).
Locate the Pulse Wire (52) in the Handlebar
(47). Insert the Pulse Wire into the large hole in
the Upright (3), and then pull the Pulse Wire out
of the top of the Console Plate (19).
Attach the Handlebar (47) and the Console
Plate (19) to the Upright (3) with two M8 x 25mm
Screws (44) and two M8 Curved Washers (8).
11. The Console (6) can use four D batteries (not
included); alkaline batteries are recommended.
Do not use old and new batteries together or
alkaline, standard, and rechargeable batter-
ies together. IMPORTANT: If the Console has
been exposed to cold temperatures, allow it
to warm to room temperature before inserting
batteries. Otherwise, you may damage the
console displays or other electronic com-
ponents. Remove the screws and the battery
covers from the back of the Console, and insert
batteries into the battery compartments. Make
sure to orient the batteries as shown by the
diagrams inside the battery compartments.
Then, reattach the battery covers.
To purchase an optional power adapter, call
the telephone number on the cover of this
manual. To avoid damaging the console,
use only a manufacturer-supplied power
adapter. Plug one end of the power adapter into
the receptacle inside the battery compartment
on the console; plug the other end into an outlet
installed in accordance with all local codes and
ordinances.
9
Large Holes
10
47
8
44
11
Battery
Cover
6
10
31
19
3
19
52
3
Battery
Cover
Receptacle