Primary Stream Video Codec Settings; Secondary Stream Video Codec Settings; Figure 4-26 Primary Stream Video Codec Settings; Figure 4-27 Secondary Stream Video Codec Settings - Honeywell HD3HDIH User Manual

IP Camera Web Client

Primary Stream Video Codec Settings

Secondary Stream Video Codec Settings

68
Note If you select 1920 x 1080p resolution for the primary stream for your
HD3HDIH(X) camera, you can select all the resolutions except 720p for your
secondary stream. If you select 1280 x 720p resolution for the primary stream
for your HD3HDIH(X) camera, you can select all the resolutions except 1080p
for your secondary stream. See
page 69.
Figure 4-26 Primary Stream Video Codec Settings
Click on the Secondary Stream tab. A warning message appears: The secondary
stream is disabled. To enable, select compression settings tab and
configure secondary stream. (HD3HDIH(X) only)
You will have access to the Secondary Stream Video Codec Settings.
Figure 4-27 Secondary Stream Video Codec Settings
Configuring the Compression Settings
Default settings shown for NTSC models
Set the Resolution
Set the Frame Rate
Set the Priority to Quality, or Bit or Frame Rate
Set the Compression Ratio
Set the Target Bit Rate
Set the Maximum Bit Rate (kbps)
Set the GOP (Group of Pictures)
Default settings shown for NTSC models
Enable/Disable the secondary stream
Set the Resolution
Set the Frame Rate
Set the Priority to Quality or Bit Rate
Set the Compression Ratio
Set the Target Bit Rate
Set the Maximum Bit Rate (kbps)
on