Figure 2-7 Wiring Connection Shown On Board - Honeywell HD3HDIH User Manual

Installation and Setup
Factory reset button
Local video out connector
(for aim and focus)
RJ45 Ethernet Connector
(see Connecting to a Network via
an RJ-45 Ethernet Connector, page
24)
24
Figure 2-7 Wiring Connection Shown on Board
Connecting to a Video Monitor
The local video out (see Figure
needed during installation to position, aim, and focus the camera. Use the provided BNC
connector to connect the video from the camera to the video input connector on your video
monitor.
Note If your installation involves a 24 V AC power source, then please wait
approximately 60 seconds after connecting to a power source for video to
appear on the local video out.
Connecting to a Network via an RJ-45 Ethernet Connector
The main video connection for your HD3 series camera will be made through your Ethernet
network connection. Connect the Ethernet connector on your camera to your network
using an Ethernet (10Base-T, 100Base-TX) cable.
Inside view
of camera
2-7) is available as a test output and should be used as