Table of Contents
Advertisement
C.
Slide belt through slot in belt clamp. See Figure 2.
D.
Verify belt and insert are installed properly, as shown in
Figure 3A. NOTE: Do not install the insert backwards as
shown in Figure 3B.
E.
Pull belt tight and secure belt to clamp with the two set
screws. NOTE: Torque set screws 300-350 in./lbs.
F.
Place weight stack pin in each plate to verify proper
installation.
G.
Without selecting any resistance, lift top weight up
and down (simulating normal operation).
H.
Have an assistant verify that the belt is moving smoothly
and is routed straight from the top pulley bracket to the
top weight belt clamp.
I.
Turn the Increment Weight Adjusting Knob to select
0 lbs or 0 kg.
7. Install back shrouds
A.
Carefully place shroud into position.
B.
Starting at the bottom replace the two BHSCS (removed in step 5C) to secure bottom
support bracket to the shroud.
C.
Install but do not tighten remaining BHSCS securing shroud.
D.
Tighten all BHSCS.
8. Install weight plate decals.
A.
Slowly and carefully peel off back side of decal.
peeling off back cover, make sure that the decals remain
attached to the front sticker. Figure 4.
B.
Insert a guide pin through each hole of the template.
guide pin can be anything
that fi ts through the weight stack hole, such as
a weight stack selector pin.
C.
Carefully align decal and rub it onto weight
plates.
D.
Carefully remove front side, leaving decals
adhering
to weight plates. See Figure 5.
Cybex VR3 12140 Prone Leg Curl Owner's Manual
NOTE: When
Weight
Stack
Figure 5
Correct belt routing
Insert
Figure 3A
Front
Back
NOTE: A
Figure 4
Guide Rod
Pounds
Wrong belt routing
Insert
Belt
Figure 3B
9 . 0
2 0
1 8 . 0
4 0
6 0
3 6 . 0
8 0
4 5 . 0
1 0 0
5 4 . 0
1 2 0
6 3 . 0
Kilograms
1 4 0
7 2 . 0
1 6 0
8 1 . 0
1 8 0
9 0 . 0
2 0 0
9 9 . 0
Belt
Assembly
Page 4-3
Advertisement
Table of Contents
