Table of Contents
Advertisement
F.
Slide spring loaded top guide rod cap down guide rod until guide rod cap is clear of frame.
NOTE: Top guide rod cap is spring loaded.
G.
Slowly release grasp of guide rod cap.
spring that will fl y if grasp is not released slowly.
H.
Remove guide rod cap and spring and set aside.
I.
Repeat steps 5F-5G for other rod guide.
J.
Carefully lean guide rods slightly outward, away from machine to clear pulley.
NOTE: Excessive pressure on guide rods may damage lower guide rod caps.
K.
Slide top weight up and out of machine and carefully set it aside.
L.
Wipe guide rods clean over entire length. Lubricate with light coating of medium weight
automotive engine oil.
M.
Have an assistant hold the guide rods vertical.
N.
Carefully align weight plate over guide rods and slowly lower weight plate.
position plates so wide edges of bushing face upward and narrow edges of bushing face downward. See Figures
1A and 1B.
Figure 1A
O.
Repeat step 5M-5N to install each weight plate.
P.
Slide top weight over guide rods.
Q.
Place springs and guide rod caps on guide rods
(removed from step 5H).
R.
Compress guide rod caps and ailgn guide rod caps with
weight frame holes and secure in place. NOTE: Guide
rod caps must snap or lock into weight frame holes.
6. Belt Routing.
A.
Remove cable tie securing belt.
B.
Route belt down and around cam. See Figure 2.
Assembly
Page 4-2
Cybex VR3 12140 Prone Leg Curl Owner's Manual
NOTE: Guide rod cap contains a compression
WIDE bushing
edge faces
upward
NOTE: When installing weight plates,
NOTE: The narrow bushing
edge must face downward.
Figure 1B
Belt Clamp
Figure 2
NARROW
bushing edge
Belt
Cam
Advertisement
Table of Contents
