Table of Contents
Advertisement
4
Tank Assembly
4.2
Installation of the Insulation
On the PL750/2S tank we recommend you
install the insulation jacket only after the tank
has been tested for leaks.
The ideal temperature to install the insulation
jacket is 60 °F (15 °C). Slight tapping on the
jacket in the direction of the seal should help
with the ease-of-installation.
V Push the insulation with holes [9] for the tank feet
under the solar combi-tank.
V Place the two insulation jacket [1] sections on the front
of the tank.
V Connect the top section of the cover strip [3].
V Fold the insulation jacket section to the back of the tank
and connect the back cover strip
V Install the short cover strips [2] of the insulation jacket
to the tank.
V Force the insulation by moving the short cover strips at
the back to the next possible step.
V Install the top insulation pieces [4] and [5], so that the
thicker top insulation [5] will end up at the same level
like the tank shell insulation [1].
V Install the insulation piece [6] for the tank connections.
V Install the top cover [7] so that there are no exposed
gaps in the insulation jacket.
V Seal the top cover with a strap and 4 coiled spring pins
[8].
14
7
6
5
4
3
2
1
Fig. 12 Installation of the PL750/2 S insulation jacket
1
Insulation
2
Short Cover strip
3
Front cover strip
4
Top insulation (2 inch/50 mm)
5
Top insulation (4 inch/100 mm)
6
Insulation clean-out cover
7
Top tank cover
8
Strap with spring pins
9
Bottom insulation
Logalux PL750/2 S - Changes may be made following technical improvements!
8
9
6 720 615 217-19.1RS
Hide quick links:
Advertisement
Table of Contents
