Mounting - La Crosse Technology WT-8112U Instruction Manual

The alarm will be automatically ON when the alarm time is set. To
deactivate the alarm (OFF), press and release once the ALM key in
normal mode display. The alarm icon will disappear the alarm is now
off.
SNOOZE SETTING
The snooze can only be activated during alarm time for a snooze
duration of 10 minutes by pressing the SNZ key on the back of the
clock.
POSITIONING THE RADIO-CONTROLLED SOLAR CLOCK:
Before permanently mounting, ensure that the radio-controlled solar
clock is able to receive WWVB signals from the desired location.
Also, extreme and sudden changes in temperature will decrease the
accuracy of the solar clock, and changes in elevation will result with
inaccurate temperatures readings for the next 12 to 24 hours. These
changes will require a 12 to 24 hour wait before obtaining reliable
data.
There are two possible ways to mount the solar clock:
use of the foldable table stands, or
wall mounting
FOLDABLE TABLE STANDS
WALL MOUNTING
1.
2.
NOTE: Always ensure that the radio-controlled
clock locks onto the screw before releasing.
The foldable table stands legs are located on the
backside. Unfold the stands out, below the
battery compartment. Once the foldout table
stands are extended, place the radio-controlled
solar clock in an appropriate location.
Install a mounting screw (not included) into a
wall—leaving approximately 3/16 of an inch
(5mm) extended from the wall.
Place the radio-controlled solar clock onto the
screw, using the hanging hole on the backside.
Gently pull the radio-controlled clock down to
lock the screw into place.
12