Replacing The Max5 Bezel; Connecting The Max5 Cables - IBM System x3690 X5 Installation And User Manual

Replacing the MAX5 bezel

To replace the MAX5 bezel, complete the following steps:
1. Read the safety information that begins on page "Safety" on page v and
2. Align the bezel alignment tabs with the chassis and press the bezel onto the

Connecting the MAX5 cables

To cable the MAX5 to the host server, see the QPI cable option documentation and
the EXA cable option documentation. Be sure to turn off the host server before you
connect any cables to or disconnect any cables from the MAX5 memory expansion
module.
The following illustration shows the locations of the connectors on the rear of the
MAX5.
Power-on
LED
Locate
LED
System
error
LED
128
System x3690 X5 Types 7147, 7148, 7149, and 7192: Installation and User's Guide
"Installation guidelines" on page 44.
chassis until it snaps into place.
EXA EXA EXA
port 1 port 2 port 3
Alignment
tab
Release
tab
QPI QPI QPI QPI
port 1 port 2 port 3 port 4
EXA port 1
link LED
EXA port 2
link LED
EXA port 3
link LED
Alignment
tab
Release
tab
Bezel
Power
connectors
AC LED (green)
DC LED (green)
Power supply
fault (error) LED