Configuring Your Router; Accessing The Web-Based Configuration Utility - Encore ENHWI-2AN4x User Manual

Chapter 3:

Configuring Your Router

3.1

Accessing the Web-Based Configuration Utility

Screenshot of the Web-Based Configuration Utility
For the initial configuration, we recommend you connecting your computer to the LAN port
with an Ethernet cable. If this cannot be done, you have to connect to the router wirelessly.
Before configuring your router through wireless
and Security are set properly. The default setting of the WLAN Router that you will use:

SSID:

Channel:

802.11 Mode:

Channel bandwidth: 20/40MHz

Security:
Note:
Before you configure the router, make sure the host PC is set on the IP subnet that can be
accessed by your cable/DSL modem.
the cable/DSL modem is 192.168.10.x, then the host PC should be set at
(where xxx is a number between 2 and 254), and the default subnet mask is
255.255.255.0.
network, make sure that SSID, Channel
default
11
802.11b/g/n mixed mode
Disable
For example, when the default network address of
9
www.encore-usa.com
192.168.10.xxx