Table of Contents
Advertisement
1.4
Back Panel and Connectors
Port / Button
Attach the external antenna(s) with R-SMA connector here.
(The
N300
Antenna
Series only has one.)
The Reset button will restore your router to the default setting.
Press and hold the button for 6 seconds to enable the reset
function.
Note: Before using the reset button, you should try two things:
1.
Disconnect and power off both your modem and router.
Wait for 30 seconds and turn on your modem FIRST. Wait
for another 60 seconds for your modem to boot up. LAST,
connect the modem back to the router and turn on the
router. Wait for another 60 seconds for the router to boot up.
Reset
RESTART your web browser to see if you can access the
Internet now.
2.
If the first solution does not work, restart your computer and
open your web browser again.
If the above-mentioned two solutions and the reset function
cannot solve your problem, contact your Internet service
provider to see if there is a problem with you modem or Internet
service.
Connect the 10/100 Ethernet Cable with RJ-45 connector here.
LAN
Most networking devices should connect to the LAN port, such
as computer, NAS, IP camera, print server, switch, and access
(1/2/3/4)
point.
Connect the 10/100 Ethernet Cable with RJ-45 connector here.
Only connect a Wide Area Network (WAN) device to this port,
WAN
such as a Cable/DSL modem.
Connect the bundled DC 12V power adapter here.
POWER
Description
Series has
two
antenna connectors, while the
6
www.encore-usa.com
N150
Advertisement
Table of Contents
