Horizon Fitness ELLIPTICAL E1201 User Manual page 8

ASSEM BLY ST eP 
SPACER (H)
CONNECTING TUBE
RIGHT PEDAL ARM
A Open HArDWAre BAG FOr STeP .
B Align the U-BrACKeT on the riGHT LOWer LiNK Arm with the CONNeCTiNG TUBe on the riGHT
PeDAL Arm.
C Slide the SPACer (H) through the U-BrACKeT and the CONNeCTiNG TUBe so that it can no longer
rotate.
D Insert 2 SPLiT TeFLON WASHerS (i) between the CONNeCTiNG TUBE and the U-BrACKeT.
e Secure the joint with a FLAT WASHer (J) and BOLT (K).
F Repeat on the other side.
HArDWAre BAG FOr STeP  CONTeNTS :
SPLIT TEFLON
WASHER (I)
28 mm
Qty: 4
1
E1201_Rev.1.4.indd 14-15
RIGHT LOWER LINK ARM
U-BRACKET
SPLIT TEFLON WASHERS (I)
FLAT WASHER (J)
BOLT (K)
SPACER (H)
72 mm axis
Qty: 2
FLAT WASHER (J) BOLT (K)
35 mm 15 mm
Qty: 2 Qty: 2
ASSEMBLY STeP 
NUT (P)
LOWER LINK ARM
A Open HArDWAre BAG FOr STeP .
B Slide SPACer (L) into LOWer LiNK Arm.
C Snap 2 SPACer riNGS (m) onto both sides of SPACer (L). While
holding SPACer riNGS (O), slide LOWer LiNK Arm into bottom
end of LOWer HANDLeBAr.
D Insert 1 BOLT (N) into LOWer HANDLeBAr and secure using 1
WASHer (O) and 1 NUT (P).
e Repeat on other side.
HArDWAre BAG FOr STeP  CONTeNTS :
SPACER (L)
Qty: 2
BOLT (N)
45 mm
Qty: 2
LOWER HANDLEBAR
FLAT WASHER (O)
BOLT (N)
SPACER (L)
SPACER RINGS (M)
Confirm that the
LOWER HANDLEBAR
and the LOWER LINK ARM
are marked R. The left
side is marked L.
SPACER RING (M)
Qty: 4
WASHER (O) NUT (P)
18 mm 18 mm
Qty: 2 Qty: 2
1
7/29/08 10:37:42 AM