Horizon Fitness ELLIPTICAL E1201 User Manual page 6

ASSE MBLY STe P 
ARC
WASHERS (E)
A Open HArDWAre BAG FOr STeP .
B Route PULSe GriP WireS from mULTi-GriP BArS through CONSOLe mAST and up to console hole.
DO NOT PiNCH WireS!
C Attach the mULTi-GriP BArS to the CONSOLe mAST using 2 BOLTS (B), 2 SPriNG WASHerS (C) and 2
FLAT WASHerS (D) in each side and 2 BOLTS (B), 2 SPriNG WASHerS (C) and 2 ArC WASHerS (e) in
the rear of the mULTi-GriP BArS.
HArDWAre BAG FOr STeP  CONTeNTS :
BOLT (B)
15 mm
Qty: 6
10
E1201_Rev.1.4.indd 10-11
PULSE GRIP WIRES
MULTI-GRIP BARS
CONSOLE MAST
FLAT
WASHERS (D)
SPRING
WASHERS (C)
BOLTS (B)
SPRING WASHER (C) FLAT WASHER (D)
15 mm 18 mm
Qty: 6 Qty: 4
ASSEMBLY STeP 
NOTe: There is NO hardware bag for this step. All hardware is pre-installed.
A Remove Pre-ATTACHeD BOLT & WASHer from riGHT PiVOT TUBe.
B Slide riGHT PeDAL Arm onto the CrANK and attach by re-inserting Pre-ATTACHeD BOLT & WASHer.
C Repeat on the other side.
D Attach the PeDAL Arm COVer to the riGHT PeDAL Arm using Pre-ATTACHeD SCreW.
ARC
WASHER (E)
17 mm e Repeat on the other side.
Qty: 2
angle view
PRE-ATTACHED WAVY WASHER PRE-ATTACHED BOLT & WASHER
CRANK PEDAL ARM PRE-ATTACHED SCREW
PEDAL ARM COVER
11
7/29/08 10:37:31 AM