Horizon Fitness E1200 User Manual page 8

ASS E MB LY ST EP 
A) Open HARDWARE BAG FOR STEP 7.
B) Slide SPACER (N) into LOWER LINK ARM.
C) Place 2 SPACER RINGS (O) on both sides of SPACER (N). While holding
SPACER RINGS (O), slide LOWER LINK ARM into bottom end of LOWER
HANDLEBAR.
D) Insert 1 BOLT (M) into LOWER HANDLEBAR and secure using 1 WASHER
(P) and 1 NUT (Q).
E) Repeat on other side.
HARDWARE BAG FOR STEP  CONTENTS :
SPACER RING (O)
Qty: 4
1
E900_E1200_Rev.2.7.indd 14-15
LOWER LINK ARM LOWER
HANDLEBAR
SPACER RINGS (O)
SPACER (N)
NUT (Q)
LOWER HANDLEBAR
WASHER (P)
BOLT (M)
PRE-ATTACHED
HARDWARE
SPACER (N)
SPACER RING (O)
LOWER LINK ARM
Confirm that the
LOWER HANDLEBAR
and the LOWER LINK ARM
are marked R. The left
side is marked L.
BOLT (M)
45 mm
Qty: 2
WASHER (P) NUT (Q)
18 mm 18 mm
Qty: 2 Qty: 2
ASSEMBLY STEP 
A) Open HARDWARE BAG FOR STEP 8.
B) Attach the INSIDE and OUTSIDE ELBOW COVERS to the right LOWER LINK ARM using 2 SCREWS (R).
C) Tighten the ELBOW COVERS together at the front using 1 SCREW (S).
D) Repeat on other side.
HARDWARE BAG FOR STEP  CONTENTS :
SPACER (N)
Qty: 2
INSIDE ELBOW COVER INSIDE ELBOW COVER
SCREWS (S)
OUTSIDE ELBOW COVER
OUTSIDE ELBOW COVER
SCREWS (R)
SCREW (R) SCREW (S)
8 mm 10 mm
Qty: 4 Qty: 2
SCREWS (S)
SCREWS (R)
1
6/16/08 9:46:14 AM