Cleaning Tool Belt - Hoover U8315960 Owner's Manual

D
5. Insert agitator brush roll
50
through belt and position belt
over gear teeth (D) on agitator brush
roll.
A
8. To replace bottom plate (A),
53
insert the four tabs on edge of
bottom plate into slots on front of
tool.
Pivot bottom plate down and snap
closed.
C
E
6. With curved ends down,
51
slide end plates (C) of agitator
brush roll into slots (E) on tool.
Belt replacement
Inspect the belt
The powered pet hair cleaning tool
belt is designed to last a long time
and is not normally replaced.
However, if the belt is cracked,
gouged or broken, it should be
replaced.
Remove tool from hose. The belt can
be seen through the top of the nozzle
or by removing the bottom plate and
belt guard (Figs. 47 and 48).
B
7. Replace belt guard (B) mak-
52
ing sure not to pinch brush bris-
tles in guard. Turn agitator brush roll,
to make sure it rotates freely.
Replace and tighten screws.
Replace belt
When replacing belt, ask for
HOOVER part No. 38528037.
1. Remove bottom plate, belt guard
and agitator brush roll as described in
Figs. 47 through 49.
F
2. Grasp turbine (E) and pull
54
firmly to remove.
3. Remove belt from turbine pulley
(F). Replace with new belt.
(Cont'd)
E
15