Power Hand Tool Belt; Powered Hand Tool - Hoover Vacuum Cleaner Owner's Manual

Powered Hand Tool (cont.)
Replacing Agitator Brush Roll
How to Replace
Remove agitator
4-25
B
including end plates (A)
and discard.
Inspect belt to ensure
that it is in good
condition. If belt is
cracked, gouged or
broken, replace it (see
following section).
A
Insert brush roll through
belt and position belt over gear teeth (B) on
brush roll.
To replace bottom plate,
4-28
insert the four tabs on
edge of bottom plate into
slots on front of tool.
Pivot bottom plate down
and snap closed.
Belt Replacement
The powered hand tool belt is designed to last a long time and is not normally replaced. However, if
the belt is cracked, gouged or broken, it should be replaced.
Inspecting the Replacing the
Belt Belt
4-29 4-30
A
B
The belt can be seen Grasp turbine (A) and
through the top of the pull firmly to remove.
nozzle or by removing
Remove belt from
the bottom plate and
turbine pulley (B).
belt guard (Figs. 4-23
Replace with new belt.
to 4-24).
4-26 4-27
A
A B
With curved ends Replace belt guard (A)
making sure not to
down, slide end plates
pinch brush bristles in
(A) of brush roll into
guard. Turn agitator,
slots (B) on tool.
to make sure it rotates
freely.
Replace and tighten
screws.
Agitator Brush Roll: What to Buy
When purchasing a new Powered Hand Tool
Agitator Brush Roll, ask for HOOVER part No.
48414-088.
With flat sides of
4-31
turbine retainers (A)
pointing down, slide
retainers into grooves
(B) in tool housing and
snap into place.
Replace brush roll, belt
A guard, and bottom plate
as described in Figs.
B
4-25 through 4-28.
Powered Hand Tool Belt: What to Buy
When purchasing a new Powered Hand Tool
Belt, ask for HOOVER part No. 38528-037.
13