Table of Contents
Advertisement
8. To replace bot-
tom plate (A),
insert the four tabs
on edge of bottom
plate into slots on
front of too].
Pivot bottom
plate
down and snap
closed.
Powered hand tool
Belt replacement
Inspecting the belt
The powered hand tool belt is designed
to last a long time ancl is not normally
replaced. However, if the belt is cracked,
gouged or broken, it should be replaced.
The belt can be
seen through
the
top of-thenozzle
or by removing
lhc
botlom plaic
aI1d
beltguard (Figs.
3-21 and 3 22).
Replacing belt
When replacing belt,
ask for HOOVER
part No. 38528037.
I. Remove bottom
plate, belt guard
and brush roll as
described in Figs.
3-21 through
3-23.
2. Grasp turbine
[E)
and pull firmly
to
remove,
3. Remove belt
from turbine
pulley
(F). Replace with
new belt.
4. With flat sides
of turbine
retainers
(O) pointing
down,
slide retainers into
grooves (H} in tool
housing and snap
into place.
5. Replace brush
roll, belt guard, and
bottom plate as
described in Figs.
3-23 through 3-26.
Lubrication
The motor
is equipped
with bearings
that contain
sufficient
lubrica-
tion for the life of the motor.
'l'he addition
of lubricant
could cause
damage. Therefore,
do not add lubricant
to motor bearings.
The agitator
is equipped
with two ball bearings that should be lubri-
cated periodically
by a Floover Sales and Service Center or an Autho-
rizecl Hoover Warranty Service Dealer (Depot).
]5
Advertisement
Table of Contents
