Drum Clamper, Drum Assy - Mitsubishi HS-HD1100U Service Manual

2-33.DRUM CLAMPER, DRUM ASSY

SET POSITION : Normal
(Removal)
1. Disconnect the LEAD CONNECTOR of the DRUM
ASSY shown in the Fig. 2-33-1.
2. Remove the two screws (a, b) fastening the DRUM
CLAMPER shown in the Fig. 2-33-1 to remove the
DRUM ASSY with the DRUM CLAMPER.
3. Rotate the DRUM CLAMPER in the Fig. 2-33-2 in the
direction shown by the arrow A to remove it from the
DRUM ASSY.
(Installation)
1. Install the DRUM CLAMPER in the Fig. 2-33-2 to the
DRUM ASSY by rotating it in the direction shown of
the arrow B.
2. Hook the Catch of the DRUM CLAMPER shown in the
Fig. 2-33-3 to the Reference Pin.
3. Fasten the screw (b) while pushing the Part A in the
direction shown by the arrow C (clockwise when
viewed from the top) as shown in the Fig. 2-33-3.
Note : Confirm at this time that the Catch of the DRUM
CLAMPER touches the side of the Reference Pin.
4. Fasten the screw (a) shown in the Fig. 2-33-3.
Note : Confirm at this time that the Catch of the DRUM
CLAMPER touches the side of the Reference Pin.
5. Connect the LEAD CONNECTOR of the DRUM ASSY
with the DRUM CLAMPER shown in the Fig. 2-33-1.
6. Connect the LEAD CONNECTOR of the DRUM ASSY
shown in the Fig. 2-33-1.
7. Perform the Item "PLAYBACK Switching Point" of the
"Circuit Adjustment" in this service manual.
8. Perform the Item "Interchangeability Adjustment of the
Mechanism".
9. Clean the DRUM ASSY shown in the Fig. 2-33-1 with
alcohol.
DRUM ASSY with
DRUM CLAMPER
MAIN PLATE ASSY
DRUM CLAMPER
Hook here to attach
DRUM CLAMPER
to DRUM ASSY.
DRUM ASSY
- 25 -
LEAD CONNECTOR
b
a
Fig. 2-33-1
Removing
Direction Installing
A
Fig. 2-33-2
Direction
B