Table of Contents
Advertisement
2-29.CHARGE SPRING, SWING LEVER,
CHARGE ASSY
SET POSITION : Normal
Remove the following parts before replacing the
CHARGE SPRING, SWING LEVER, CHARGE ASSY.
Refer to the corresponding items to install them.
• STAY PLATE (Item 2-2)
• BOTTOM ASSY (Item 2-3)
• MOTOR HOLDER (Item 2-16)
• PINCH ARM CAP (Item 2-17)
• PINCH UNIT (Item 2-17)
• BRAKE CAM PLATE (Item 2-19)
(Removal)
1. Remove the CHARGE SPRING shown in the Fig. 2-
29 from the SWING LEVER.
2. Remove the SWING LEVER shown in the Fig. 2-29.
3. Release the Part a of the CHARGE ASSY shown in
the Fig. 2-29 from the Part b of the MAIN PLATE
ASSY to remove the CHARGE ASSY.
(Installation)
1. Apply GREASE (MULTEMP AC-DM)[859D055O90] to
the parts on the MAIN PLATE ASSY specified in the
Fig. 2-29.
2. Install the CHARGE ASSY.
3. Install the SWING LEVER inserting the Part c of the
SWING LEVER in the Fig. 2-29 into the groove in the
MAIN PLATE ASSY.
4. Install the CHARGE SPRING to the SWING LEVER.
2-30.LOADING ARM ASSY (SP), LOADING
ARM ASSY (TU)
SET POSITION : Upside down
(Removal)
1. Release the catch (a) of the LOADING ARM ASSY
(SP) shown in the Fig. 2-30-1 to remove the
LOADING ARM ASSY (SP).
Note : Be sure to replace the removed LOADING ARM
ASSY (SP) with a new one.
2. Remove the screw (b) fastening the SPACER PLATE
shown in the Fig. 2-30-1 to remove the SPACER
PLATE.
3. Remove the LOADING ARM ASSY (TU) shown in the
Fig. 2-30-1.
CHARGE SPRING
c
SWING LEVER
Front
Back
Both Sides
(Front/Back)
REEL DISK (SP side)
MAIN PLATE ASSY
- 21 -
a
CHARGE ASSY
b
MAIN PLATE ASSY
Fig. 2-29
b
SPACER PLATE
LOADING
ARM ASSY (TU)
LOADING ARM
a
ASSY (SP)
GREASE (MULTEMP AC-DM)
Fig. 2-30-1
Advertisement
Table of Contents
