Table of Contents
Advertisement
(Installation)
Note : Install the BRAKE BELT (TU) so that its Felt Side
touches the REEL DISK (TU side).
The GREASE applied to the BRAKE CAM PLATE
and the MAIN PLATE ASSY should not adhere on
the Felt Side of the BRAKE BELT (SP).
1. Apply GREASE (MULTEMP AC-DM)[859D055O90] to
the parts on the MAIN PLATE ASSY specified in the
Fig. 2-27.
2. Install the REEL DISK (TU side).
3. Install the BRAKE BELT (TU) to the BRAKE (TU).
4. Install the BRAKE (TU).
5. Hook the BRAKE BELT (TU) to the REEL DISK (TU
side).
2-28.SHIFT LEVER
SET POSITION : Normal
Remove the following parts before replacing the SHIFT
LEVER. Refer to the corresponding items to install them.
• STAY PLATE (Item 2-2)
• BOTTOM ASSY (Item 2-3)
• MOTOR HOLDER (Item 2-16)
• PINCH ARM CAP (Item 2-17)
• PINCH UNIT (Item 2-17)
• BRAKE CAM PLATE (Item 2-19)
• BRAKE (TU) (Item 2-27)
• REEL DISK (TU side) (Item 2-27)
(Removal)
1. Move the SHIFT SLIDER in the Fig. 2-28 in the
direction shown by the arrow A to release it from the
SHIFT LEVER.
2. Move the SHIFT LEVER in the Fig. 2-28 in the
direction shown by the arrow B to remove it.
(Installation)
1. Apply GREASE (MULTEMP AC-DM)[859D055O90] to
the parts on the new SHIFT LEVER specified in the
Fig. 2-28.
2. Apply GREASE (MULTEMP AC-DM)[859D055O90] to
the parts on the MAIN PLATE ASSY specified in the
Fig. 2-28.
3. Install the SHIFT LEVER so that its Part (a) shown in
the Fig. 2-28 will be positioned under the MAIN
PLATE ASSY.
4. Install the SHIFT SLIDER to the SHIFT LEVER.
SHIFT LEVER
a
B
A
SHIFT SLIDER
Apply GREASE (MULTEMP AC-DM) to the parts
- 20 -
Back
Back
Back
MAIN PLATE ASSY
Fig. 2-28
.
Advertisement
Table of Contents
