Cyclic Defect - Oki OKIPAGE 8iM Maintenance Manual

4
Vertical black belt/stripe
• Replace the I/D unit.
• Has this error been recovered?
• Yes
• No Replace the LED head.
• Has this error been recovered?
• Yes
• No Replace the main control board, high-voltage power supply board(P2H) or high-voltage
power supply board(P6L).
5

Cyclic defect

Caution: After replacing the I/D unit, reset the drum counter. (Refer to "Replacing the Drum
Cartridge" in "User's Manual".)
41260201TH Draft
End
Caution: After replacing the I/D unit, reset the drum counter. (Refer to
"Replacing the Drum Cartridge" in "User's Manual".)
End
Caution: Set the LED head drive time when replacing the LED head. (See
Section 4.2.1.)
EP drum 1.98" (50.3 mm)
Developing roller 1.44" (36.6 mm)
Toner supply roller 2.63" (66.8 mm)
Charge roller 0.81" (20.6 mm)
Cleaning roller 0.81" (20.6 mm)
Transfer roller 1.71" (43.4 mm)
Heat roller 2.46" (62.5 mm)
Pressure roller B 2.35" (59.7 mm)
Cycle Remedy
Clean or replace the I/D unit.
Replace the I/D unit.
Replace the I/D unit.
Replace the I/D unit.
Replace the I/D unit.
Replace the I/D unit.
Replace the heater Assy.
Replace pressure roller B.
77 / 106